Having problems with your Samsung SyncMaster 930B 19" LCD Flat Panel Monitor ?

My Samsung Syncmaster 930B was working fine unti I disconnected and then reconnected it to my computer. Now I get a black screen with a roaming box that says, "check signal cable".


Answers :

Hello
\015\0121st Pull all power from pc from the wall.Plug back in and start pc up.
\015\012While starting hold down the f8 key and select safe mode.
\015\012
\015\012once in go to control panel and select display.
\015\012
\015\012set resoulution to default 60 hz and screen size to 800 by 600.
\015\012
\015\012Reboot.
\015\012
\015\012You may need to readjust your screen again.
\015\012
\015\012Hope this helps.
This model has both Analog and digital inputs, there should be a button on the front of the monitor that will allow you to switch between them.
Repair Help & Product Troubleshooting for Samsung SyncMaster 930B 19" LCD Flat Panel Monitor

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Missing NTLDR file


The first thing to do is try to change back whatever hardware or software change you just made (this could be as simple as leaving a floppy disk in the drive or you need to reseat the IDE cables). If the contents of the drive are especially important ... ASUS Eee PC 2G Surf Notebook

My Samsung Syncmaster 930B was working fine unti I disconnected and then reconnected it to my computer. Now I get a black screen with a roaming box that says, "check signal cable".


Hello\015\0121st Pull all power from pc from the wall.Plug back in and start pc up.\015\012While starting hold down the f8 key and select safe mode.\015\012\015\012once in go to control panel and select display.\015\012 ... Samsung SyncMaster 930B 19" LCD Flat Panel Monitor

Dell 1800FP, no signal found (analog). Green LED on, get message


Check if your signal cable is properly connected to your system unit and make sure that non of the pins of your signal cable is broken.if any of the pins are broken,try and change the whole signal cable and re-connect it again\015\012after foll ... Dell UltraSharp 1800FP 18.1" LCD Flat Panel Monitor

Wont go to normal start up screen!!!


The screen that you're seeing is the self-test of the monitor, as it's already stated. It's commonly caused by having no signal coming from the computer to the monitor. You were advised to check the monitor cable, if you have already done that, then ... E-Machines eView 17f3 17" Flat CRT Monitor

Zenith L13V36 When I turn-on the power button to my 13" television, the screen goes on for about 1/2 second with no sound or picture (it's just black, but you can see the channel number in the upper right hand corner), then it automatically shuts off. What to do? Thanks so much for any assistance.


That sounds like a bad power adapter, a bad inverter , or a bad controller board.When TV does not start, and sometimes you hear a clicking noise, that means that the TV is on protect mode.\015\012\015\012\015\012\015\012Try fi ... Zenith L13V36 13" Flat Panel LCD Monitor

Lcd monitor power light flashing with no img. seems 2 be frozen


The display is in safe mode and you will need to reset the display to get the display out of the safe mode. There are 2 different model revisions. Please choose the method that will match your revision. Depending on the revision of the monitor, one ... Planar PL1910M (Black) 19 in. Flat Panel LCD Monitor

Why wont my hp connect to my home wireless - HP Pavilion ze4400 Notebook


\015\012There are a few things you can do to help reliability\015\012You should first make sure that the modem and router are individually \015\012set up correctly.\015\012I do have a guide for that.\015\012Once that is ... HP Pavilion ze4400 Notebook

Cannot connect to internet


First check ipaddress \015\012 Click Start -run- type cmd hit enter for XP or Start -search-type cmd hit enter in Vista. On the DOS black screen after the blinking cursor type ipconfig hit enter check the ipaddress if are getting ipaddress other than ... Fujitsu AMILO Pro V1000 Notebook

Acer L5100 and TV Tuner


Try normal arial first.\015\012If OK, try freeview box again. \015\012Check what tuner card you have fitted in Device Manager and check specs on google. Can it receive satellite freeview?\015\012May be new drivers - check Tuner card ... PC Desktops

Black screen after a year of use


Sine a flashlight on the screen and check for a dim image. If you see a dim image the back light needs to be replaced. After doing that you will want to try using another monitor cable and see if that helps. If it doesn't with the computer on and the ... Acer AL1916W 19" LCD Monitor

I have a HP tower and compaq monitor, does this affect the speakers on the monitor? Since I changed the towers out the sound hasn't worked


HP and Compaq are actually now one company. So depending on the age of your tower and the age of the monitor they should be compatible.First you should check the small speaker icon located in the task bar in the lower right hand corner of ... HP Compaq WF1907 Monitor

Can't get picture


Hello matthew95765,\015\012\015\012The TV is working, the message is coming from the dish box. What you need to do is to determine if the dish box is connected to the dish and that it has signal at the box, because the message it is delivering ... SVA-USA SVA HD4208TIIIBU 42" Plasma Monitor

Lcd screen goes black after a few seconds


Check your vga cable that is connected on your cpu,for some lose connection,it must be fitted if you still don't get any display check your cpu.have some other monitor for isolation,if you dont have bring it on s repair center,your cpu has a problem. ... Computer Monitors

SIR, PLEASE GIV ME THE BEST SOLUTION FOR FOLLOWING PROBLEM WITH MY LENOVO 3000 Y410 LAPTOP (WITH XP AS O.S. ) ON MY [email protected] AS EARLY AS POSSIBLE. SIR, MY LAPTOP SCREEN STAYS BLACK AFTER TURNING ON IT.IT DOESN?T DISPLAY XP CD ALSO.


You can't even get into the BIOS. Hard drive failure?Here's what the manual say's about black screen.Verify that: The monitor cable is securely attached to the rear of the monitor and to the rear of the computer. The monitor ... Lenovo 3000 Y410 Laptop

Main screen only has three boxes BGR


The monitor is telling you it's not getting a signal from the computer. The message is displayed to show the monitor is on and can display an image, but the computer is not sending video. Probably the computer is not starting up, or there has been a ... HP Pavilion a305w (DM181AR) PC Desktop

Sansung 915N no video


The monitor gets the wrong signal from the computer (refresh rate too high or scan rate too high ) check the screen refresh rate from Display properties / Settings tab / Advanced button / Monitor settingsworse case: damaged hardware ... Samsung SyncMaster 915N 19" Flat Panel LCD Monitor

No display on SyncMaster 710N


I used 2 resistor of 100 ohms (1/8W) to make one of 50 ohms. Like others instruction, just put the 50 ohms resistor between pins 5 and 6 of this chip and the problem is solved. ... Samsung SyncMaster 710N 17" LCD Monitor

My picture is smaller than the screen size.


Dear User,\015\012\015\012This usually happens by selecting the wrong screen resolution or the resolution not supported by your Monitor.\015\012However you can solve this by getting into the "Safe Mode" .\015\012\015\012 ... Samsung SyncMaster 2233BW 22" LCD Monitor

When it powers up the screen is fine then it goes black with no signal box, then if you turn it off and on again screens comes back for few seconds and then off again, sying no signal. Viewsonic LCD monitor VP720b


The lcd has three parts the screen plate(windows)/the logic(vga)/the inverter(power plug). Parts that go are the backlight ccfl's, behind the plate, and parts of the inverter, ie capacitors, all three take a bit of power from the inverter. The self t ... ViewSonic VA720 17" LCD Flat Panel Monitor

940mw - Compatibility


First thing i would check is your settings. See if windows is reconizing two monitors. If not then you will need to tell it to find it. Hook up your second monitor goto add new hardware and see if windows finds it. If it doesnt find it then i would g ... Samsung SyncMaster 940MW 19" LCD Monitor

No composite input signal


`Hi,\015\012 If the monitor is making the noise , the monitor circuit baord has gone bad.\015\012If you have purchased the monitor on a seprate order from dell it would be covered under 3 yr warranty. If the same has been bought with th ... Dell UltraSharp 1907FP 19" LCD Monitor

Ntldr is missing, this information is regularly coming even though I am trying to format my laptop acer 4715z with cd also when once it was it catched booting and started the process of formating after a few steps ahead it showed me that no hardware is available , kindly tell me what to do? now it is not booting with the cd which button or setting is required to solve the problem and able to format my laptop


1. You must have a copy of "ntldrusb.zip" file.USB: Right click the ntldrusb.zip file and choose "Extract All" Next>Next>FinishThen Insert your USB Stick into the working computer (remove any other USB sticks, and be sure there isn't anyt ... Acer Aspire 5610-4648 Notebook

The screen is black and I cant get it to the safe


Okay. Now that I know what you clarified, let me resolve the issue.\015\012\015\012Now, if you do hear a beep from the computer when you turn it on and the fans spin, that means the BIOS is working and that's a start. If the video light ... eMachines EL1210-11 PC Desktop

Monitor comes up shows "acer" then says no signal and goes black


The interface between the monitor and the cable might need replacement. Please check it. ... Acer AL2016 W 20" TFT LCD Monitor
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || electronic-servicing.com || Terms of Use || Contact || Privacy Policy
Load time: 1.0827 seconds